Graco LineLazer IV 250SPS Installation And Operation Manual page 11

Broken hydraulic pump or compressor shafts may
result, if not aligned properly. Always verify compres-
sor alignment whenever a compressor is installed or
the belt is tightened or replaced.
8. Install coupler guard using three pan head screws
with flatwashers and lockwashers.
Chain Coupler Maintenance
Periodic chain coupler lubrication is necessary to ensure
proper operation of your striper regularly once a month.
1. Remove three pan head screws with flatwashers
and lockwashers from chain coupler guard.
2. Remove chain coupler guard.
3. Lubricate coupler chain with Justice Brothers heavy
duty chain lube or equivalent (NLGI grade 1 or 2
grease).
4. Install coupler guard using three pan head screws
with flatwashers and lockwashers.
Complete Frame Assembly
NOTE: If desired, rotate recoil 90° counter-clockwise.
1. Use 9/16 wrench to tighten bottom screws (MM) to
hardware shown.
332230G
NOTICE
ti21200a
2. Use 9/16 in. wrench to tighten hopper basket (XX)
and base bolts.
3. Install plastic end caps (ZZ) into frame. Use rubber
mallet to pound end caps into place.
ti21500a
200HS Pressurized Bead System Kit 16R955
MM
XX
ZZ
ti20884a
ti21194a
11