Graco LineLazer IV 250SPS Installation And Operation Manual page 16

LL250 Pressurized Bead System Kit 16R962
18. Use 9/16 wrench to tighten bottom screws (M) to
hardware shown.
19. Assemble hopper bracket (X) and base (Y) with
hardware provided. Install carriage bolts with the
heads facing the paint tanks. Use 9/16 in. wrench to
tighten bolts. Loosen all eight nuts 1/4 turn.
2.674"
16
Compressor Alignment (LL250)
M
Install Compressor Assembly
1. Position compressor and bracket assembly on
frame. Align compressor coupler sprocket with
chain coupler installed on mounting plate coupler.
Install three screws, snug all three screws down
then back the screws off 1/4 turn.
ti20500a
ti24390a
ti24481a
332230G