Graco LineLazer IV 250SPS Installation And Operation Manual page 17

0.80 +/- 0.050
Maintain gap set at factory
2. Move compressor and mounting bracket up to the
chain coupler on the mounting plate so that the two
sprockets contact each other.
3. Move compressor assembly up or down (vertical)
and left or right (horizontal) until the compressor is
aligned with the hydraulic pump.
332230G
Vertical Adjustment
1. Place a straight edge at the bottom of correspond-
ti24339a
2. Use 9/16 in. wrench to tighten compressor bracket
ti24386a
LL250 Pressurized Bead System Kit 16R962
ing teeth of the two sprockets and raise or lower the
compressor to adjust until the offset misalignment is
minimized (use a straightedge for accurate align-
ment). Repeat this at both the top and bottom of the
sprockets. The allowable offset misalignment is
0.005 to 0.010.
screws (VV).
VV
ti24341a
ti24482a
17