Graco LineLazer IV 250SPS Installation And Operation Manual page 20

LL250 Pressurized Bead System Kit 16R962
Bead Tank Mounting
1. When only one bead tank is being installed, it
should be placed on the side of the frame furthest
from the compressor to best distribute weight.
2. Place bead tank on supporting base with outlet
fittings facing compressor.
3. Place clamping band around tank and secure with
mounting hardware shown below. Tighten until
there is no movement between clamp and bead
tank. NOTE: The flats on the clamp are not intended
to touch when hopper bracket is tightened.
20
ti24485a
NOTE: Position handle to best suit filling needs.
Loosen bolt (AA) to help swivel, then retighten.
ti24483a
AA
ti20704a
332230G