Graco LineLazer IV 250SPS Installation And Operation Manual page 7

EE CC
4. Use star bit (supplied) to remove four screws from
shroud. Remove original fan grill.
FF
5. Use existing hardware to install new open-centered
fan grill (FF). Do not over-tighten. Make sure fan
protrudes out, not into the unit. Discard or store old
close-centered fan grill.
FF
Shroud
FF
6. Close belt shroud (BB) with new fan grill onto unit.
NOTE: You may need to flex shroud around
extended shaft on the fan pulley.
332230G
DD DD
ti20525c
ti20713a
ti20714a
Shroud
BB
7. Place key (GG) in keyway opening. Tap into place so
that face of key sits recessed slightly from face of hub.
GG
8. Push chain coupler against the shoulder on the
mounting plate coupler.
9. Use 1/8 in. Allen wrench to secure coupler set
screw. Torque to 58-62 in-lb (6.6-7.0 N•m).
10. Use hardware (shown below) to mount compressor
to compressor bracket (KK). Make certain that the
square of the carriage bolt heads are seated in the
compressor bracket slots.
ti20519a
200HS Pressurized Bead System Kit 16R955
ti20516a
KK
ti21198c
ti21196a
ti24336a
7