Graco LineLazer IV 250SPS Installation And Operation Manual page 14

LL250 Pressurized Bead System Kit 16R962
E C D
4. Use existing hardware to install new open-centered
fan grill (F). Make sure fan protrudes out, not into
the unit. Discard or store old close-centered fan grill.
Shroud
F
5. Install belt shroud with new fan grill onto unit.
NOTE: You may need to flex shroud around
extended shaft on the fan pulley.
6. Place key (G) in keyway opening. Tap into place so
that face of key sits recessed slightly from face of
hub.
G
7. Push chain coupler against the shoulder on the
mounting plate coupler.
14
D
ti20525b
Shroud
ti20519a
B
ti20518a
ti20516a
8. Use 1/8 in. Allen wrench to secure coupler set
screw. Torque to 58-62 in-lb (6.6-7.0 N•m).
9. Use hardware (shown below) to mount compressor
to compressor bracket. Make certain that the square
of the carriage bolt heads are seated in the com-
pressor bracket slots.
10. Snug all four nuts down then back the nuts off 1/4
turn. Bracket KK should slide in the slots with some
effort.
ti24336a
ti24480a
332230G