Graco LineLazer IV 250SPS Installation And Operation Manual page 21

Air Tank Mounting
1. Install air tank to frame mount as shown below and
use 9/16 in. wrench to tighten two screws (BB).
BB
332230G
BB
ti24486a
LL250 Pressurized Bead System Kit 16R962
2. Use 11/16 in. wrench to attach braided hose (CC)
from air tank to compressor.
ti24487a
3. Install 36 in. nylon air line (DD) from top of regulator
to swivel fitting on top of bead hopper. Cut air hose
to desired length. Push air line into fitting until end
touches bottom of fitting.
CC
DD
ti20493a
21