Graco LineLazer IV 250SPS Installation And Operation Manual page 15

11. Use rubber mallet or wood block to position right
frame mount (L) flush to LL250 frame (this location
will be adjusted to help center the compressor with
the drive pulley).
L
12. Place right frame mount (L) onto LL250 frame in
location shown below (approximately 1 in. from
cross member of LL250 frame). NOTE: To ensure
flush sitting, scrape frame free of any raised debris
on frame surface.
L
13. Cut any existing tie wraps that interfere (they will be
replaced later with new tie straps).
14. Loosely install two screws (M) and two locknuts (N)
through bottom of frame mount. NOTE: See align-
ment section then use 9/16 in. wrench to fully
tighten.
332230G
15. Secure hydraulic lines with zip ties.
16. Position left frame mount (W) on LL250 frame.
Inches
Centimeter
ti20511a
17. Make sure left and right frame mounts are aligned.
ti20512a
LL250 Pressurized Bead System Kit 16R962
M
Remove any zip ties in the way. Use a rubber mallet
to tap into place if needed.
W
The left leg should mirror the right leg location from
LL250 frame cross member.
N
ti20509a
ti20507a
ti20501a
Inches
Centimeter
ti20502a
15