JVC UX-F70MD Service Manual page 7

Removing the
assembly section (See Fig.6 and 7)
Prior to performing the following procedure, remove
the rear cover and the side panels.
1. Remove the two screw D on each side of the body.
2. Release the joint b on each side of the body and
remove the cassette mechanism assembly section in
the direction of the arrow.
3. Disconnect the card wires from connector CN705,
CN743 and CN744 on the system control board on
the left side of the body.
Removing the fan assembly (See Fig.6)
Prior to performing the following procedure, remove
the rear panel and the right side panel.
1. Disconnect the wire from connector CN907 on the
main board on the right side of the body.
2. Remove the two screws E
assembly.
Removing the MD mechanism assembly
section (See Fig.8)
Prior to performing the following procedure, remove
the rear cover, the side panels, the cassette
mechanism assembly section and the fan assembly.
1. Disconnect the card wire from connector CN721 on
the system control board.
2. Disconnect the card wire from connector CN522 on
the underside of the MD mechanism assembly
section.
3. Remove the four screws F and the MD mechanism
assembly section upward.
cassette mechanism
attaching the fan
D
Joint b
Fan assembly
E
Cassette mechanism assembly
CN743
CN744
System control board
CN522
F
System
control board
CN721
F
UX-F70MD/UX-F72MD
Cassette mechanism assembly
E
Main board
CN907
Fig.6
D
CN705
Joint
Fig.7
MD mechanism assembly
F
F
Front panel
Fig.8
b
1-7