JVC UX-F70MD Service Manual page 26

UX-F70MD/UX-F72MD
8. Reattach the UD base while engaging the four pins
on both sides of the UD base to the notches of the
loading mechanism base and placing the edge
(marked e') of the cartridge holder assembly under
the hook e of the loading mechanism base. (Fig.23)
9. Reattach the slide base (R) while fitting the two pins
on another side of the UD base to the slots of the
slide base (R). (Fig.24)
ATTENTION: Fit the part v of the slide base (R) to
the part w on the inward side of the
cam gear rib. (Fig.25)
10. Reattach the slide base (L) on the slide base (R)
while fitting the two pins on another side of the UD
base to the slots of the slide base (L) (Fig.25). Make
sure the two slots of the slide base (L) are fitted to
the two bosses marked E'
screws E. (Fig.26)
Ref: To expedite the work, bring up the UD base
slightly when fitting each pin to the appropriate
notch.
Slide base (R)
1-26
and tighten the two
E'
Slide base (L)
E
E'
Fig.26
Pin
Hook e'
Hook e
Hook e'
Loading mechanism base
Fig.23
Slide base (R)
Pin
Pin
Part w
Fig.24
Slide base (R)
Part v
Fig.25
Pin
E
Part v
Slide base (L)
Cam gear
Part w