Advertisement
UX-F70MD/UX-F72MD
Removing the door switch board
Prior to performing the following procedure, remove
the relay board.
1.
Loosen the screw U attaching the door switch.
2.
Remove the door switch board while releasing it from
the joint e.
CAUTION:
When reattaching the door switch board,
fit it to the joint e
operating state of the switch before
tightening the screw U.
Removing the LCD section
Prior to performing the following procedure, remove
the relay board.
1.
Loosen the two screws V attaching the lock lever.
2.
Push the part f of the lock lever in the direction of
the arrow as shown in Fig.33-1 / 33-2 and disengage
the LCD section from the front panel assembly.
CAUTION:
Because the LCD may come off, hold it
when loosening the screws V.
LCD section
1-14
(See Fig.30 and 31)
and check the
(See Fig.32 to 34)
Front panel assembly
Joint f
Fig.34
Drive motor assembly
Fig.30
U
Door switch board
Switch section
Fig.31
Lock lever
V
Front panel assembly
Fig.32
Lock lever
f
Fig.33-1
U
Door switch board
Joint e
Joint e
Lock lever
V
Lock lever
f
Fig.33-2
Advertisement
