Advertisement
Removing
the
assembly (See Fig.20)
Prior to performing the following procedure, remove
the rear cover, the side panels, the cassette
mechanism assembly section, the system control
board, the MD mechanism assembly section and the
main board.
1.
Disconnect the wire from connector CN809 on the
AC jack board.
2.
Cut off the band setting the wire on the CD
mechanism cover.
3.
Remove the four screws M
transformer assembly.
Removing the CD mechanism assembly
Prior to performing the following procedure, remove
the rear cover, the side panels, the cassette
mechanism assembly section, the system control
board, the front panel assembly section, the MD
mechanism assembly section, the main board / the
tuner board and the AC jack board.
1.
Cut off the band setting the wire on CD mechanism
cover.
2.
Release the wire extending from the headphone jack
board from the three notches of the CD mechanism
cover on the left side of the body.
3.
Remove the four screws N on the left and right side
of the CD mechanism cover. Then remove the CD
mechanism cover upward.
4.
Remove the three screws O
mechanism assembly.
power
transformer
attaching the power
(See Fig.21 to 23)
attaching the CD
Power transformer
assembly
M
Fig.20
CD mechanism cover
Band
Notches
Fig.21
CD mechanism cover
CD mechanism assembly
N
Fig.22
O
Fig.23
UX-F70MD/UX-F72MD
M
AC jack board
CN809
Band
CD mechanism cover
CD mechanism assembly
Notch
Headphone
jack board
N
Band
O
CD mechanism assembly
1-11
Advertisement
