Advertisement
Disassembly method
<Main body>
Removing the main board
1.
Turn over the body and disconnect the card wire
from connector CN408 and the flexible wire from
CN407 on the main board.
2.
Remove the two screws A attaching the main board.
Slide the main board in the direction of the arrow to
release the two joints a with the single flame.
3.
Solder part b on the pickup in the body. Disconnect
the flexible harness from connector CN321 and
CN451 on the underside of the main board. Then
remove the main board.
Removing the mechanism cover
1.
Remove the four screws B
body.
2.
Move the mechanism cover toward the front to
disengage the front hook of the mechanism cover
from the internal loading assembly (Joint c). Then
remove the mechanism cover upward.
(See Fig.1 and 2)
(See Fig.3)
on both sides of the
A
(Bottom)
Joint b
Fig.1
CN451
Pickup
Fig.2
Joint c
B
Fook
Joint c
Fig.3
UX-F70MD/UX-F72MD
A
Main board
CN408
CN407
Joint b
Main board
CN321
Solder part b
Mechanism cover
B
1-17
Advertisement
