Advertisement
UX-F70MD/UX-F72MD
2) MD section
(1) Setup of the TEST MODE 1
While pressing both the POWER
key and FORWARD SKIP key, turn
on the primary power supply.
FL indication
MD TEST MODE 1
Setup is complete.
(3) Adjustment of the playback laser power
Set up the MD TEST MODE 1.
Press the stop key
the remote controller.
Insert the laser power
meter sensor.
Press the "2" key on
the remote controller.
Set up the playback
laser power.
Increase the laser
power with the F.
SKIP key on the
remote controller.
Adjust the power to be 0.68 mW or
more. If the value exceeds 0.68 mW,
approximate it to 0.68 mW as
accurately as possible.
Press the stop key
the remote controller.
Press the MD EJECT
key on the main unit.
Setup of the MD laser
power is complete.
1-36
(2) Initializing the EEPROM
(For initializing the EEPROM,
it is the prerequisite that the
test mode has been
completely set up. Use the
remote controller for the
following operation.)
Among the keys on the main
unit, only the EJECT key is
used for ejecting the disk.)
(4) Adjustment of the recording laser power
Decrease the laser
power with the B.
SKIP key on the
remote controller.
Set up the MD TEST MODE 1.
Press the stop key
the remote controller.
Insert the laser power
meter sensor.
Press the "4" key on
the remote controller.
Set up the recording
laser power.
Decrease the laser
Increase the laser
power with the B.
power with the F.
SKIP key on the
SKIP key on the
remote controller.
remote controller.
Adjust the power to be 6.23 mW or
more. If the value exceeds 6.23 mW,
approximate it to 6.23 mW as
accurately as possible.
Press the stop key
the remote controller.
Press the MD EJECT
key on the main unit.
Setup of the MD laser
power is complete.
Initialization of the EEPROM
Press the OPEN/CLOSE
key on the main unit.
Press the REC SPEED key
on the remote controller.
Press the STOP key on
the remote controller.
Press the STOP key on
the remote controller.
Initialization is complete.
Advertisement
