Bosch DDU 8 Manual page 82

10 | Analog and Frequency Inputs
82 / 160
1. Click 'Measurement Sources' in the Toolbox.
2. Expand the list of 'I/O Channels' by clicking on '+' in the DDU 8 Project Tree.
3. Drag the 'Velocity' digital signal source from the Toolbox and drop it on the
desired 'REV' input channel in the DDU 8 Project Tree.
4. The 'Velocity Wizard' opens.
5. Click 'Finish' when done.
6. Enter channel name and description.
7. Click 'OK' when done.
The channel is inserted into the DDU 8 Project Tree.
Channel is
linked to
REV01
Available measurements for channel:
Measurement label
raw_name
raw_name_fi
name
name_fi
DDU 8 Manual
Special functionality for sensors
with frequency offset (e.g.
Correvit) Set to '0' for wheelspeed
measurement
Number of teeth on the pulse
wheel
Circumference of wheel for
speed calculation
Choose data type of the
measurement variable
Enter name to automatically
create a new measurement
sheet
Input pin
Number of
has hall teeth
interface
Function
mV value of sensor
filtered mV value of sensor
physical value of sensor
filtered physical value
Wheel
circumference
Bosch Motorsport