Honda TRX400EX FOURTRAX 1999 Service Manual page 196

REAR WHEEL/SUSPENSION
Apply grease to new needle bearing rollers.
Carefully press the needle bearing into the shock arm
Press the mark-
and shock link until the depth from the outer surface
of
ing side the
is 5.5 mm (0.22 in).
bearing
TOOLS:
Driver
Attachment, 24
Pilot, 17 mm
Make sure that the needle rollers are in position.
Apply grease to new dust seal lips and install them
into the pivots until they are seated against the nee-
dle bearings.
Install the pivot collars.
INSTALLATION
Install the shock arm into the frame with the "UP"
Note the installa-
mark facing up and the bolt and nut.
tion of the pivot
bolts. All bolts
are installed
from the right
side.
install the shock link over the shock arm and into the
link), bolts and nuts.
Connect the shock absorber to the shock link with the
bolt and nut.
Tighten the linkage and shock absorber mounting nuts.
TORQUE:
Shock arm-to-frame: 59
Shock arm-to-shock l i n k
59 N m (6.0 kgfm, 43 Ibf4tl
Shock link-to-swingarm:
44 N m 14.5 kgfm, 33 IbfW
Shock absorber mounting:
59 N m (6.0 kgfm, 43 Ibf4t)
13-1
2
-
0010000
x
26 mm 07746-0010700
07746-0040400
PILOT