Honda TRX400EX FOURTRAX 1999 Service Manual page 170

FRONT WHEEL/SUSPENSION/STEERING
HUB ASSEMBLY
Drive in a new inner bearing (brake disc side1 squarely
with the marking side facing up until it
Install the distance collar with the large dia. facing
the inner bearing.
Drive in a new outer bearing squarely with the mark-
ing side facing up until
TOOLS
Driver
Attachment. 42
Pilot, 20 mm
Outer bearing (wheel sideJ:
Driver
Attachment, 32
Pilot, 15 mm
Do not
get
power will be reduced.
Install the brake disc with the stamp facing up (away
from the hub).
Install new disc bolts and tighten them in 2 - 3 steps.
TORQUE: 42 Nm (4.3 kgfm, 31 Ibf4tl
Apply grease to new dust seal lips.
Install the dust seals into the wheel hub until they are
flush with the hub surface.
TOOLS:
Disc side:
Assembly collar
Wheel side:
Attachment, 32 x 35 mm
Install the side collars.
Install the wheel hubldisc onto the knuckle and the
hub nut.
Tighten the hub nut
ther tighten it until its grooves align with the cotter
pin hole.
TORQUE: 59
Install a new cotter pin.
Secure the brake hose with the clamp on the knuckle.
Install the brake caliper with new mounting bolts and
tighten them.
TORQUE: 30 N m 13.1 kgfm,
Install the disc guard and tighten the bolt.
12-8
I S
is fully seated.
it
07749
x
47 07746
07746-0040500
07749-0010000
35 07746
07746-0040300
grease on the brake disc or stopping
07965
07746
the specified torque and fur-
to
fully seated.
-
0010000
-
0010300
ATTACHMENT AND
-
0010100
-
-
0010100
DRIVER
PILOT
\
DISC
BOLTS