Honda TRX400EX FOURTRAX 1999 Service Manual page 158

Remove the mainshaft bearing using the special
tools.
TOOLS:
Mainshaft bearing:
Bearing remover, 17 mm
Remover handle
Sliding weight
Heat the crankcase 80°C
gun and remove the balancer bearing.
Always wear insulated gloves when handling the
crankcase after
CAUTION:
Do
n o t use a torch to heat the case;
Apply oil to new bearings.
Drive the countershaft and balancer bearings in with
the marking side facing up using the special tools.
TOOLS
Countershaft bearing:
Driver
Attachment, 52
Pilot, 25 mm
Balancer bearing:
Driver
Attachment, 32 x 35 mm
Pilot, 12 mm
Drive the mainshaft bearing in with the sealed side
facing down using the special tools.
TOOLS:
Driver
Attachment, 37 x 40 mm
Pilot,
Install new countershaft and gearshift spindle oil
seals.
Install the crankshaft (page 11-10),
Install the transmission (page 11-7).
Assemble the crankcase halves (page 11-14).
11-14
07936-3710300
07936-3710100
-
07936
07936-3710200
evenly using a heat
(176°F)
it has been heated.
may cause
it
-
07749 0010000
-
x 55 mm 07746 0010400
-
07746 0040600
07749-0010000
07746-0010100
07746-0040200
07749-0010000
07746-0010200
-
07746 0040400