288
4-5. Using the driving support systems
Region B
(The pedestrian detection function is not available)
The pre-collision system is enabled and the system determines that the possibility of a
frontal collision with a vehicle is high.
Each function is operational at the following speeds:
Pre-collision warning:
●
• Vehicle speed is between approximately 10 and 110 mph (15 and 180 km/h).
• The relative speed between your vehicle and the vehicle ahead is approximately 7
mph (10 km/h) or more.
Pre-collision brake assist:
●
• Vehicle speed is between approximately 19 and 110 mph (30 and 180 km/h).
• The relative speed between your vehicle and the vehicle ahead is approximately 19
mph (30 km/h) or more.
Pre-collision braking:
●
• Vehicle speed is between approximately 10 and 110 mph (15 and 180 km/h).
• The relative speed between your vehicle and the vehicle ahead is approximately 7
mph (10 km/h) or more.
The system may not operate in the following situations:
If a 12-volt battery terminal has been disconnected and reconnected and then the vehi-
●
cle has not been driven for a certain amount of time
If the shift lever is in R
●
If VSC is disabled (only the pre-collision warning function will be operational)
●
If the PCS warning light is flashing or illuminated
●
Pedestrian detection function
■
The pre-collision system detects pedestrians
based on the size, profile, and motion of a
detected object. However, a pedestrian may not
be detected depending on the surrounding
brightness and the motion, posture, and angle of
the detected object, preventing the system from
operating properly. (→P. 292)
*
2
: For countries/areas specified as Region B (→P. 282), the pedestrian detection func-
tion may not be available.
Cancelation of the pre-collision braking
■
If either of the following occur while the pre-collision braking function is operating, it will
be canceled:
The accelerator pedal is depressed strongly.
●
The steering wheel is turned sharply or abruptly.
●
RX450h_U_OM0E023U
*
2