Grizzly G0808 Owner's Manual page 23

10. Install power feed unit onto right side of
bracket assembly and temporarily tighten hex
bolts (see Figure 24).
11. Move power feed unit until power feed gear
teeth align with X-axis leadscrew gear teeth,
then tighten cap screws from Step 8 (see
Figure 24).
12. Loosen hex bolts from Step 10, adjust power
feed unit until power feed gear meshes with
X-axis leadscrew gear, then fully tighten hex
bolts (see Figure 24).
Power Feed
Gear
X-Axis
Leadscrew
Gear
Figure 24. Left side of power feed bracket with
attached power feed unit mounted to right side of
bracket.
13. Install direction lever handle, as shown in
Figure 25.
14. Remove adhesive backing from gear guard
and install over X-axis table gear, as shown
in Figure 25.
Handle
Figure 25. Gear cover installed.
Model G0808 (Mfd. Since 11/15)
15. Loosen and remove factory-installed limit
Hex Bolt
(1 of 2)
16. Slide one limit stop all the way to left end of
17. Remove factory-installed stop plate, then
Cap Screw
(1 of 2)
18. Install X-axis limit switch to mounting block
Gear
Guard
stops, then insert both accessory limit stop
assemblies into groove in table, as shown in
Figure 26.
Accessory Limit Stop
Assembly (1 of 2)
Figure 26. Accessory limit stop assembly
mounted in table groove (1 of 2 shown).
table, and slide the other stop all the way to
right end.
use its mounting screws to install limit switch
mounting block in its place (see Figure 27).
using (2) included M8-1.25 x 12 cap screws
and 8mm flat washers (see Figure 27).
Mounting
Block
Figure 27. X-axis limit switch installed.
Groove
X-Axis
Limit Switch
x 2
-21-