Table of Contents
Advertisement
Master Power Switch
The Master Power Switch (see Figure 33) toggles
the incoming power ON and OFF. It can be locked
in the OFF ("0") position to prevent unauthorized
use.
To lock the switch in the OFF position, rotate the
switch to the OFF position, press the locking tab
in, then insert a padlock with a maximum shank
diameter of
⁄
" through the hole in the tab and
3
16
switch body (see Figure 33).
Master Power
Switch
Figure 33. Master power switch.
Table Movement
The table travels in three directions (see Figure 34).
This travel is controlled by table handwheels and
the Z-axis crank handle. Additionally, the table
can be moved along the X- and Z-axis with the
power feed and manually rotated 360° around the
column.
X-Axis or Longitudinal Travel
(Left & Right)
Z-Axis or
Vertical Elevation
(Up & Down)
Figure 34. The directions of table movement.
Model G0808 (Mfd. Since 11/15)
Locking Tab
with
⁄
" Hole
3
16
Y-Axis or
Cross Travel
(In & Out)
Graduated Collars
The table handwheels have graduated collars
(see Figure 35) that are used to determine table
movement in 0.001" increments with one full revo-
lution equaling 0.100" of travel.
Additionally, each collar has a thumbscrew that is
used to adjust the dial to "0".
Graduated
Figure 35. Locations of graduated collars.
Table Locks
Use table locks to increase the rigidity of the table
when movement in that axis is not required for the
operation.
Refer to Figure 36 to identify the locks for each
table axis.
X-Axis Locks
Z-Axis
Figure 36. Location of table locks.
Always keep table locked in place unless
table movement is required. Unexpected
table and workpiece movement could cause
tooling to bind with workpiece, which may
damage tooling or workpiece.
Collars
Y-Axis
Lock
Locks
-27-
Advertisement
Table of Contents
