Power Feed Gears - Grizzly G0808 Owner's Manual

Power Feed Gears

To lubricate the Z-axis power feed gears, always
make sure column rack has adequate lubrication
(see Page 39), which will disburse throughout the
Z-axis power feed gears.
To lubricate the X-axis power feed gears, follow
the instructions below.
Grease Type .....................NLGI #2 or Equivalent
Grease Amount ........Two Pumps of Grease Gun
Check/Add Frequency .......160 Hrs. of Operation
Materials Needed
Double-Sided Adhesive Tape ............ As Needed
Rubbing Alcohol and Shop Rags ...... As Needed
To lubricate X-axis power feed gears:
1. DISCONNECT MACHINE FROM POWER!
2. Remove gear guard (see Figure 71).
Gear
Guard
Figure 71. Location of gear guard.
-42-
3. Brush a light coat of grease on teeth of
power feed gear and X-axis table gear (see
Figure 72).
X-Axis
Table Gear
Qty
Figure 72. Lubrication points for X-axis power
4.
Use rubbing alcohol or other appropriate sol-
vent/cleaner to thoroughly clean grease/resi-
due from mating surfaces of gear guard, then
re-install guard using double-sided adhesive
tape.
Power Feed
Gear
feed gears.
Model G0808 (Mfd. Since 11/15)