Table of Contents
Advertisement
Installing/Removing
Tooling
This machine features a spindle that accepts R-8
tooling. Make sure speed range lever is set to "L"
to prevent spindle rotation when installing/remov-
ing tooling.
Cutting tools are sharp and
can easily cause laceration
injuries. Always protect
your hands with leather
gloves or shop rags when
handling cutting tools.
Installing Tooling
Tools Needed
Hex Wrench 3mm .............................................. 1
Wrench or Socket 17mm ................................... 1
To Install Tooling:
1.
DISCONNECT MACHINE FROM POWER!
2.
Clean any debris or oily substances from
inside spindle taper and mating surface of
tooling.
Note: Debris or oily substances can prevent
the tooling and spindle from properly mating.
This condition can cause excessive vibra-
tion, poor cutting results, or tool/workpiece
damage.
3.
Remove motor cover (see Figure 42).
Motor Cover
Removed
Figure 42. Motor cover removed.
-30-
4.
Align tool slot (see Figure 43) with pin inside
spindle, then insert tooling all the way into
spindle.
Figure 43. Example of R8 tooling with alignment
Qty
5.
With one hand holding tool in place, insert
drawbar into spindle from top of head, then
thread it into tool by hand until snug (see
Figure 44).
Figure 44. Threading drawbar into tooling.
6.
Use wrench to tighten drawbar an additional
⁄
turn.
1
4
Note:
Overtightening makes tool removal difficult
and may damage arbor and threads.
7.
Re-install motor cover.
Alignment Slot
slots.
Do
not
overtighten
Model G0808 (Mfd. Since 11/15)
drawbar.
Advertisement
Table of Contents
