Grizzly G0808 Owner's Manual page 22

6. Slide X-axis leadscrew gear onto X-axis
leadscrew and tighten set screw (see
Figure 19).
X-Axis
Leadscrew
Gear
Set Screw
Figure 20. Installing X-axis table lock.
7. Install X-axis power feed bracket assem-
bly onto left end of table, then tighten pre-
installed mounting bolts (see Figure 21).
X-Axis Power Feed
Bracket Assembly
Figure 21. X-axis power feed bracket assembly
mounted to table.
-20-
X-Axis
Leadscrew
Mounting Bolts
8. Loosen hex bolts shown in Figure 22, then
remove left side of X-axis power feed bracket
assembly.
Left Side
of Bracket
Assembly
Figure 22. Left side of X-axis power feed bracket
assembly removed.
9.
Install left side of bracket assembly onto
X-axis power feed unit with (2) M6-1 x 25 cap
screws and (2) 6mm flat washers (see Figure
23). Do not fully tighten cap screws.
Cap Screws
Left Side
of Bracket
Assembly
Figure 23. Left side of bracket assembly
mounted to power feed unit.
Model G0808 (Mfd. Since 11/15)
Hex Bolts
Power
Feed
Unit