Omron SYSMAC C200H-ASC02 Operation Manual page 17

Back Panel
6: The pin numbers for port 2 corrected in the diagram.
Left-Side DIP Switch Settings
1 2 3 4 5 6
Pin No.
Setting
Not Used. Always set this pin to OFF.
Program No.
These pins select which program will be executed on
power application or reset. The program number can be
changed later with the PGEN command.
Pin No.
Setting
Automatic program transfer from EEPROM to RAM
Pin No.
Setting
Start mode
Pin No.
Setting
OFF : 0
ON : 1
7 8
Screen size
6 7 8
0 0 0 40 columns x 7 lines
1 0 0 40 columns x 8 lines
0 1 0 40 columns x 15 lines
1 1 0 40 columns x 16 lines
0 0 1 80 columns x 15 lines
1 0 1 80 columns x 16 lines
0 1 1 80 columns x 24 lines
1 1 1 80 columns x 25 lines
3 4 Function
0 0
No. 1
1 0
0 1 No. 2
1 1 No. 3
2 Function
Set this pin to "0" if only the
0
RAM is to be used.
Set this pin to "1" to automatically
transfer the program from the EE-
1
PROM to RAM on power applica-
tion or reset.
1
Manual start mode
In this mode, the BASIC program is not
started upon power application. To start
the program, either press the START/
0
STOP switch or issue a start command
from the personal computer connected
to port 1.
Automatic start mode
In this mode, the BASIC program is
1
started automatically on power applica-
tion.
Section 1-2
Screen Size
Function
5