DataCard Sp35 Installation Manual page 161

19
What you see
The topcoat shows wavy
lines along the length of the
card (woodgrain or clouds).
The topcoat shows opaque
areas along a short edge of
the card (clouds).
The topcoat has a spotty
appearance, especially on
the leading edge of the card.
Possible causes
The temperature for applying
topcoat is too high.
The temperature for applying
topcoat is too high.
The supply material was
attached to the take-up spool
and then wound in the wrong
direction.
Solutions
Lower the laminator
temperature for this material.
Contact your service provider
for guidance in correcting this
problem.
The next card should process
correctly. If it does not,
remove the cartridge and turn
the take-up spool clockwise
several turns.
SP Series Info Central: Troubleshooting