Sr3 Goose Configuration Via The Iec 61850 Configurator; Introduction To The Sr3 Iec61850 Device Configurator - GE 350 Communications Manual

SR3 GOOSE CONFIGURATION VIA THE IEC 61850 CONFIGURATOR

SR3 GOOSE configuration via the IEC 61850
configurator

Introduction to the SR3 IEC61850 Device Configurator

4–18
The SR3 family of relays supports the IEC61850 GOOSE messaging service.
This service offers SR3 relays the ability to exchange digital and analog information with
other relays supporting the same service, at speeds suitable for protection. The
configuration of GOOSE messaging within the SR3 series of relays can be accomplished in
one of three ways:
1. For those users familiar with both the SR3 configuration menus and IEC61850
implementation within the SR3, they may prefer to configure the relays directly
through the SR3 menus if the GOOSE messaging is restricted to the exchange of
digital point status.
2. For those not familiar with SR3 IEC61850 implementation and/or the SR3 menus, the
above SR3 Simplified GOOSE Message tool may save time and effort, and is again
restricted to the exchange of digital status information.
3. The SR3 IEC61850 Device Configurator may be used with SR3 relays supporting the
"3E" option and itself supports the configuration of both digital and analog items for
transmission.
This section of the Communications Guide deals with configuration of GOOSE messages
via the SR3 IEC61850 Device Configurator.
CHAPTER 4: SR3 IEC61850 GOOSE
350 FEEDER PROTECTION SYSTEM – COMMUNICATIONS GUIDE