9.4.1 Add/Edit Policy Route
Click Add New Policy Route in the Policy Route screen or click the Edit icon next to a policy. Use this
screen to configure the required information for a policy route.
Figure 62 Policy Route: Add/Edit
The following table describes the labels in this screen.
Table 42 Policy Route: Add/Edit
LABEL
Active
Route Name
Source IP
Address
Source Subnet
Mask
Protocol
Source Port
Source MAC
Source Interface
(ex: br0 or
LAN1~LAN4)
WAN Interface
Apply
Cancel
9.5 RIP
Routing Information Protocol (RIP, RFC 1058 and RFC 1389) allows a device to exchange routing
information with other routers.
Chapter 9 Routing
DESCRIPTION
Select Enable or Disable to activate or deactivate the policy route.
Enter a descriptive name of up to 8 printable English keyboard characters, not including spaces.
Enter the source IP address.
Enter the source subnet mask address.
Select the transport layer protocol (TCP or UDP).
Enter the source port number.
Enter the source MAC address.
Type the name of the interface from which the matched traffic is sent.
Select a WAN interface through which the traffic is sent. You must have the WAN interface(s)
already configured in the Broadband screens.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
VMG8924-B10D/B30D User's Guide
140