The Wps Screen - ZyXEL Communications VMG8924-B10D User Manual

7.5 The WPS Screen

Use this screen to configure WiFi Protected Setup (WPS) on your VMG.
WPS allows you to quickly set up a wireless network with strong security, without having to configure
security settings manually. Set up each WPS connection between two devices. Both devices must
support WPS. See
Note: The VMG applies the security settings of the SSID1 profile (see
you want to use the WPS feature, make sure you have set the security mode of SSID1 to
WPA2-PSK or No Security.
Click Network Setting > Wireless > WPS. The following screen displays. Select Enable and click Apply to
activate the WPS function. Then you can configure the WPS settings in this screen.
Figure 36 Network Setting > Wireless > WPS
The following table describes the labels in this screen.
Table 24 Network Setting > Wireless > WPS
LABEL
General
WPS
Add a new device with WPS Method
Method 1
WPS
Method 2
Chapter 7 Wireless
Section 7.9.8.3 on page 115
DESCRIPTION
Select Enable to activate WPS on this VMG.
Use this section to set up a WPS wireless network using Push Button Configuration (PBC). Select
Enable and click Apply to activate WPS method 1 on the VMG.
Click this button to add another WPS-enabled wireless device (within wireless range of the
VMG) to your wireless network. This button may either be a physical button on the outside of
device, or a menu button similar to the WPS button on this screen.
Note: You must press the other wireless device's WPS button within two minutes of
pressing this button.
Use this section to set up a WPS wireless network by entering the PIN of the client into the VMG.
Select Enable and click Apply to activate WPS method 2 on the VMG.
VMG8924-B10D/B30D User's Guide
for more information about WPS.
103
Section 7.2 on page 94). If