The Applications Screen - ZyXEL Communications VMG8924-B10D User Manual

Table 56 Port Forwarding: Add/Edit (continued)
LABEL
End Port
Translation Start
Port
Translation End
Port
Server IP
Address
Configure
Originating IP
Originating
IP
Protocol
Wake up this
target by Wake
on LAN(WOL)
MAC address of
WOL device
OK
Cancel

11.3 The Applications Screen

This screen provides a summary of all NAT applications and their configuration. In addition, this screen
allows you to create new applications and/or remove existing ones.
To access this screen, click Network Setting > NAT > Applications. The following screen appears.
Figure 76 Network Setting > NAT > Applications
The following table describes the labels in this screen.
Table 57 Network Setting > NAT > Applications
LABEL
Add New
Application
#
Chapter 11 Network Address Translation (NAT)
DESCRIPTION
Enter the last port of the original destination port range.
To forward only one port, enter the port number in the Start Port field above and then enter it
again in this field.
To forward a series of ports, enter the last port number in a series that begins with the port
number in the Start Port field above.
This shows the port number to which you want the VMG to translate the incoming port. For a
range of ports, enter the first number of the range to which you want the incoming ports
translated.
This shows the last port of the translated port range.
Enter the inside IP address of the virtual server here.
Select Enable to enter the source IP address of WAN interface.
Enter the source IP address of WAN interface.
Select the protocol supported by this virtual server. Choices are TCP, UDP, or TCP/UDP.
Select this to turn on the virtual server remotely.
Enter the MAC address of the device to turn it on.
Click OK to save your changes.
Click Cancel to exit this screen without saving.
DESCRIPTION
Click this to add a new NAT application rule.
This is the index number of the entry.
VMG8924-B10D/B30D User's Guide
164