ZyXEL Communications VMG8924-B10D User Manual page 30

Table 5 Navigation Panel Summary (continued)
LINK TAB
System System
User Account User Account
Remote MGMT Services
Management
Trust Domain
SNMP SNMP
Time Time
Email Email Notification
Notification
Log Setting Log Setting
Firmware Firmware
Upgrade
Upgrade
Backup/Restore Backup/Restore
Reboot Reboot
Diagnostic Ping&Traceroute
&Nslookup
802.1ag
OAM Ping
Chapter 2 The Web Configurator
FUNCTION
Use this screen to set Device name and Domain name.
Use this screen to change user password on the VMG.
Use this screen to enable specific traffic directions for network services.
Use this screen to view a list of public IP addresses which are allowed to
access the VMG through the services configured in the Maintenance >
Remote Management screen.
Use this screen to configure SNMP (Simple Network Management
Protocol) settings.
Use this screen to change your VMG's time and date.
Use this screen to configure up to two mail servers and sender addresses
on the VMG.
Use this screen to change your VMG's log settings.
Use this screen to upload firmware to your VMG.
Use this screen to backup and restore your VMG's configuration
(settings) or reset the factory default settings.
Use this screen to reboot the VMG without turning the power off.
Use this screen to identify problems with the DSL connection. You can
use Ping, TraceRoute, or Nslookup to help you identify problems.
Use this screen to configure CFM (Connectivity Fault Management) MD
(maintenance domain) and MA (maintenance association), perform
connectivity tests and view test reports.
Use this screen to view information to help you identify problems with the
DSL connection.
VMG8924-B10D/B30D User's Guide
30