Configuring Static Joining - HP A6600 Configuration Manual

Configuring an MLD version globally
To do...
1. Enter system view.
2. Enter MLD view.
3. Configure an MLD version
globally.
Configuring an MLD version on an interface
To do...
1. Enter system view.
2. Enter interface view.
3. Configure an MLD version on
the interface.

Configuring static joining

After an interface is configured as a static member of an IPv6 multicast group or an IPv6 multicast source
and group, it will act as a virtual member of the IPv6 multicast group to receive IPv6 multicast data
addressed to that IPv6 multicast group for the purpose of testing IPv6 multicast data forwarding.
Follow these steps to configure a static member of an IPv6 multicast group or an IPv6 multicast source and
group:
To do...
1. Enter system view.
2. Enter interface view.
3. Configure a static member of
an IPv6 multicast group or an
IPv6 multicast source and
group.
Before you configure an interface on an IPv6 PIM-SM-capable router as a static member of an IPv6
multicast group or an IPv6 multicast source and group, if the interface is IPv6 PIM-SM enabled, you must
configure the interface as an IPv6 PIM-SM DR. If this interface is MLD enabled but not IPv6 PIM-SM
enabled, you must configure the interface as an MLD querier. For more information about IPv6 PIM-SM
and a DR, see
A static member port does not respond to queries from the MLD querier. When you configure an interface
as a static member port or remove this configuration on the interface, the interface does not unsolicitedly
send any MLD report or an MLD done message. In other words, the interface is not a real member of the
IPv6 multicast group or the IPv6 multicast and source group.
Use the command...
system-view
mld
version version-number
Use the command...
system-view
interface interface-type
interface-number
mld version version-number
Use the command...
system-view
interface interface-type
interface-number
mld static-group
ipv6-group-address [ source
ipv6-source-address ]
"Configuring IPv6 PIM."
Remarks
—
—
Optional.
MLDv1 by default.
Remarks
—
—
Optional.
MLDv1 by default.
279
Remarks
—
—
Required.
By default, an interface is not a
static member of any IPv6
multicast group or IPv6 multicast
source and group.