HP A6600 Configuration Manual page 152

Router C
Procedure
Configure IP addresses and unicast routing
1.
Configure the IP address and subnet mask for each interface as per
steps are omitted here.
Configure OSPF on the routers in the PIM-SM domain to ensure network-layer reachability among them.
Detailed configuration steps are omitted here.
Enable IP multicast routing, and enable PIM-SM and IGMP
2.
# Enable IP multicast routing on Router A, enable PIM-SM on each interface, and enable IGMP on
GigabitEthernet 0/0/0, which connects Router A to the stub network.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface GigabitEthernet 0/0/0
[RouterA-GigabitEthernet0/0/0] igmp enable
[RouterA-GigabitEthernet0/0/0] pim sm
[RouterA-GigabitEthernet0/0/0] quit
[RouterA] interface GigabitEthernet 0/0/3
[RouterA-GigabitEthernet0/0/3] pim sm
[RouterA-GigabitEthernet0/0/3] quit
[RouterA] interface GigabitEthernet 0/0/1
[RouterA-GigabitEthernet0/0/1] pim sm
[RouterA-GigabitEthernet0/0/1] quit
The configuration on Router B and Router C is similar to that on Router A. The configuration on Router D
and Router E is also similar to that on Router A except that it is not necessary to enable IGMP on the
corresponding interfaces on these two routers.
Configure a C-BSR and a C-RP
3.
# On Router D, configure the service scope of RP advertisements, specify a C-BSR and a C-RP, and set the
hash mask length to 32 and the priority of the C-BSR to 10.
<RouterD> system-view
[RouterD] acl number 2005
[RouterD-acl-basic-2005] rule permit source 225.1.1.0 0.0.0.255
[RouterD-acl-basic-2005] quit
[RouterD] pim
[RouterD-pim] c-bsr GigabitEthernet 0/0/1 32 10
[RouterD-pim] c-rp GigabitEthernet 0/0/1 group-policy 2005
[RouterD-pim] quit
# On Router E, configure the service scope of RP advertisements, specify a C-BSR and a C-RP, and set the
hash mask length to 32 and the priority of the C-BSR to 20.
<RouterE> system-view
[RouterE] acl number 2005
[RouterE-acl-basic-2005] rule permit source 225.1.1.0 0.0.0.255
[RouterE-acl-basic-2005] quit
[RouterE] pim
GE0/0/0 10.110.2.2/24
GE0/0/1 192.168.3.1/24
GE0/0/4
GE0/0/5
141
192.168.9.2/24
192.168.4.1/24
Figure 46. Detailed configuration