HP A6600 Configuration Manual page 163

Figure 48 Network diagram for BIDIR-PIM configuration
Device Interface
Router A GE1/0/1
S2/0/1
Router B GE1/0/1
S2/0/1
S2/0/2
Router C S2/0/1
S2/0/2
Loop0
Procedure
Configure IP addresses and unicast routing
1.
# Configure an IP address and subnet mask for each interface as per
are omitted here.
# Configure OSPF on the routers in the BIDIR-PIM domain to ensure network-layer reachability among
them. The configuration steps are omitted here.
Enable IP multicast routing, PIM-SM, BIDIR-PIM, and IGMP.
2.
# On Router A, enable IP multicast routing, enable PIM-SM on each interface, and enable BIDIR-PIM.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface GigabitEthernet 1/0/1
[RouterA-GigabitEthernet1/0/1] pim sm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface serial 2/0/1
[RouterA-Serial2/0/1] pim sm
[RouterA-Serial2/0/1] quit
[RouterA] pim
[RouterA-pim] bidir-pim enable
IP address Device
192.168.1.1/24 Router D
10.110.1.1/24
192.168.2.1/24
10.110.1.2/24 Source 1
10.110.2.1/24 Source 2
10.110.2.2/24 Receiver 1
10.110.3.1/24 Receiver 2
1.1.1.1/32
152
Interface IP address
GE1/0/1 192.168.3.1/24
GE1/0/2 192.168.4.1/24
S2/0/1 10.110.3.2/24
- 192.168.1.100/24
- 192.168.4.100/24
- 192.168.2.100/24
- 192.168.3.100/24
Figure 48. The configuration steps