HP A6600 Configuration Manual page 97

Enable IP multicast routing, enable PIM-SM on each interface, and enable IGMP and IGMP SSM
2.
mapping on the host-side interface.
# Enable IP multicast routing on Router D, enable PIM-SM on each interface and enable IGMPv3 and
IGMP SSM mapping on GigabitEthernet 1/0/1.
<RouterD> system-view
[RouterD] multicast routing-enable
[RouterD] interface GigabitEthernet 1/0/1
[RouterD-GigabitEthernet1/0/1] igmp enable
[RouterD-GigabitEthernet1/0/1] igmp version 3
[RouterD-GigabitEthernet1/0/1] igmp ssm-mapping enable
[RouterD-GigabitEthernet1/0/1] pim sm
[RouterD-GigabitEthernet1/0/1] quit
[RouterD] interface GigabitEthernet 1/0/2
[RouterD-GigabitEthernet1/0/2] pim sm
[RouterD-GigabitEthernet1/0/2] quit
[RouterD] interface GigabitEthernet 1/0/3
[RouterD-GigabitEthernet1/0/3] pim sm
[RouterD-GigabitEthernet1/0/3] quit
# Enable IP multicast routing on Router A, and enable PIM-SM on each interface.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface GigabitEthernet 1/0/1
[RouterA-GigabitEthernet1/0/1] pim sm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface GigabitEthernet 1/0/2
[RouterA-GigabitEthernet1/0/2] pim sm
[RouterA-GigabitEthernet1/0/2] quit
[RouterA] interface GigabitEthernet 1/0/3
[RouterA-GigabitEthernet1/0/3] pim sm
[RouterA-GigabitEthernet1/0/3] quit
The configuration on Router B and Router C is similar to that on Router A.
Configure a C-BSR and a C-RP
3.
# Configure C-BSR and C-RP interfaces on Router D.
[RouterD] pim
[RouterD-pim] c-bsr GigabitEthernet 1/0/3
[RouterD-pim] c-rp GigabitEthernet 1/0/3
[RouterD-pim] quit
Configure the SSM group range
4.
# Configure the SSM group range 232.1.1.0/24 on Router D.
[RouterD] acl number 2000
[RouterD-acl-basic-2000] rule permit source 232.1.1.0 0.0.0.255
[RouterD-acl-basic-2000] quit
[RouterD] pim
[RouterD-pim] ssm-policy 2000
[RouterD-pim] quit
86