HP A6600 Configuration Manual page 360

Procedure
Configure IPv6 addresses and unicast routing
1.
Configure the IPv6 address and prefix length for each interface as per
configuration steps are omitted here.
Configure OSPFv3 on the routers in the IPv6 PIM-SM domain to ensure network-layer reachability among
them. Detailed configuration steps are omitted here.
Enable IPv6 multicast routing and IPv6 administrative scoping, and enable IPv6 PIM-SM and MLD
2.
# Enable IPv6 multicast routing and IPv6 administrative scoping on Router A, enable IPv6 PIM-SM on
each interface, and enable MLD on the host-side interface GigabitEthernet 1/0/1.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] pim ipv6
[RouterA-pim6] c-bsr admin-scope
[RouterA-pim6] quit
[RouterA] interface GigabitEthernet 1/0/1
[RouterA-GigabitEthernet1/0/1] mld enable
[RouterA-GigabitEthernet1/0/1] pim ipv6 sm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface Serial 2/0/1
[RouterA-Serial2/0/1] pim ipv6 sm
[RouterA-Serial2/0/1] quit
The configuration on Router E and Router I is similar to the configuration on Router A.
# On Router B, enable IPv6 multicast routing and IPv6 administrative scoping, and enable IPv6 PIM-SM
on each interface.
<RouterB> system-view
[RouterB] multicast ipv6 routing-enable
[RouterB] pim ipv6
[RouterB-pim6] c-bsr admin-scope
[RouterB-pim6] quit
[RouterB] interface GigabitEthernet 1/0/1
[RouterB-GigabitEthernet1/0/1] pim ipv6 sm
[RouterB-GigabitEthernet1/0/1] quit
[RouterB] interface Serial 2/0/1
[RouterB-Serial2/0/1] pim ipv6 sm
[RouterB-Serial2/0/1] quit
[RouterB] interface pos 5/0/1
[RouterB-Pos5/0/1] pim ipv6 sm
[RouterB-Pos5/0/1] quit
[RouterB] interface pos 5/0/2
[RouterB-Pos5/0/2] pim ipv6 sm
[RouterB-Pos5/0/2] quit
The configuration on Router C, Router D, Router F, Router G, and Router H is similar to the configuration
on Router B. The specific configuration steps are omitted here.
Configure an IPv6 admin-scope zone boundary
3.
# On Router B, configure POS 5/0/1 and POS 5/0/2 as the boundary of IPv6 admin-scope zone 1.
349
Figure 100. The detailed