HP A6600 Configuration Manual page 220

Procedure
Configure IP addresses for router interfaces as shown in
1.
are omitted).
Configure OSPF (The detailed configuration steps are omitted).
2.
Enable IP multicast routing, PIM-SM and IGMP, and configure a PIM-SM domain border.
3.
# Enable IP multicast routing on Router A, and enable PIM-SM on each interface.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] pim sm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface pos 5/0/0
[RouterA-Pos5/0/0] pim sm
[RouterA-Pos5/0/0] quit
The configuration on Router B and Router D is similar to the configuration on Router A.
# Enable IP multicast routing on Router C, enable PIM-SM on each interface, and enable IGMP on the
host-side interface GigabitEthernet 1/0/1.
<RouterC> system-view
[RouterC] multicast routing-enable
[RouterC] interface serial 2/0/0
[RouterC-Serial2/0/0] pim sm
[RouterC-Serial2/0/0] quit
[RouterC] interface serial 2/0/1
[RouterC-Serial2/0/1] pim sm
[RouterC-Serial2/0/1] quit
[RouterC] interface gigabitethernet 1/0/1
[RouterC-GigabitEthernet1/0/1] pim sm
[RouterC-GigabitEthernet1/0/1] igmp enable
[RouterC-GigabitEthernet1/0/1] quit
# Configure a PIM domain border on Router A.
[RouterA] interface pos 5/0/0
[RouterA-Pos5/0/0] pim bsr-boundary
[RouterA-Pos5/0/0] quit
# Configure a PIM domain border on Router B.
[RouterB] interface pos 5/0/0
[RouterB-Pos5/0/0] pim bsr-boundary
[RouterB-Pos5/0/0] quit
Configure C-BSRs and C-RPs
4.
# Configure the C-BSR and C-RP on Router A.
[RouterA] interface loopback 0
[RouterA-LoopBack0] ip address 1.1.1.1 32
[RouterA-LoopBack0] pim sm
[RouterA-LoopBack0] quit
[RouterA] pim
[RouterA-pim] c-bsr loopback 0
Figure 58
209
(The detailed configuration steps