HP A6600 Configuration Manual page 67

Network diagram
Figure 22 Network diagram for RPF route alteration configuration
Procedure
Configure IP addresses and unicast routing
1.
Configure the IP address and subnet mask for each interface as per
steps are omitted here.
Enable OSPF on the routers in the PIM-DM domain. Ensure the network-layer interoperation among the
routers in the PIM-DM domain. Ensure that the routers can dynamically update their routing information
by leveraging the unicast routing protocol. The specific configuration steps are omitted here.
Enable IP multicast routing, and enable PIM-DM and IGMP
2.
# Enable IP multicast routing on Router B, enable PIM-DM on each interface, and enable IGMP on
GigabitEthernet 1/0/1.
<RouterB> system-view
[RouterB] multicast routing-enable
[RouterB] interface GigabitEthernet 1/0/1
[RouterB-GigabitEthernet1/0/1] igmp enable
[RouterB-GigabitEthernet1/0/1] pim dm
[RouterB-GigabitEthernet1/0/1] quit
[RouterB] interface GigabitEthernet 1/0/2
[RouterB-GigabitEthernet1/0/2] pim dm
[RouterB-GigabitEthernet1/0/2] quit
[RouterB] interface GigabitEthernet 1/0/3
[RouterB-GigabitEthernet1/0/3] pim dm
[RouterB-GigabitEthernet1/0/3] quit
# Enable IP multicast routing on Router A, and enable PIM-DM on each interface.
<RouterA> system-view
Figure
56
22. The detailed configuration