Enabling The Igmp Host Tracking Function; Configuring Igmp Ssm Mapping; Prerequisites - HP A6600 Configuration Manual

Configuring IGMP fast leave processing on an interface
To do...
1. Enter system view.
2. Enter interface view.
3. Configure IGMP fast leave
processing,

Enabling the IGMP host tracking function

With the IGMP host tracking function, the switch can record the information of the member hosts that are
receiving multicast traffic, including the host IP address, running duration, and timeout time. You can
monitor and manage the member hosts according to the recorded information.
Enabling the IGMP host tracking function globally
To do...
Enter system view.
1.
2. Enter public network IGMP
view/VPN instance IGMP
view.
3. Enable the IGMP host tracking
function globally.
Enabling the IGMP host tracking function on an interface
To do...
1. Enter system view.
2. Enter interface view.
3. Enable the IGMP host tracking
function on the interface.

Configuring IGMP SSM mapping

Due to some possible restrictions, some receiver hosts on an SSM network might run IGMPv1 or IGMPv2.
To provide SSM service support for these receiver hosts, configure the IGMP mapping feature on the last
hop router.

Prerequisites

Before configuring the IGMP SSM mapping feature, complete the following tasks:
• Configure any unicast routing protocol so that all devices in the domain are interoperable at the
network layer
Configure basic functions of IGMP
•
Use the command...
system-view
interface interface-type
interface-number
igmp fast-leave [ group-policy
acl-number ]
Use the command...
system-view
igmp [ vpn-instance vpn-instance-name ]
host-tracking
Use the command...
system-view
interface interface-type interface-number
igmp host-tracking
78
Remarks
—
—
Required.
Disabled by default.
Remarks
—
—
Required.
Disabled by default.
Remarks
—
—
Required.
Disabled by default.