Using The Batteries; Installing The Battery - Intermec PB51 User Manual

Chapter 1 — Using the PB51 Mobile Label and Receipt Printer

Using the Batteries

The PB51 uses a rechargeable 2200 mAh lithium-ion b attery (Model
AB13) for power. You must fully charge the battery before you can use
the PB51. A fully charged battery can last up to on e week without
needing to be recharged when the printer is in Standby mode.
Use Intermec Model AB13 battery only. Use of anothe
may present a risk of re or explosion.
The Model AB13 battery may present a re or chemic
hazard if mistreated. Do not disassemble, heat above 100°C
(212°F), or incinerate.
Dispose of used batteries promptly. Keep away from children.

Installing the Battery

Make sure you fully charge the battery before you use your PB51. You
can charge the battery before or after you install them into the PB51.
To install the battery
1 Lay the PB51 upside down on a at surface.
2 Insert the battery with the tab facing away from the front control
8
panel.
PB51 Mobile Label and Receipt Printer User's Guide
r battery
al burn