Intermec PB51 User Manual page 24

Chapter 1 — Using the PB51 Mobile Label and Receipt Printer
To load media for self-strip printing
1 Complete Steps 1 through 4 in the previous procedur e.
2 Open the self-strip door in the media cover.
3 Remove a label from the roll of media so that you a re left with
4 Feed the label liner over the self-strip bar and out the back of the
5 Close the media cover until it latches and press down on the self-
6 Pull on the liner to tighten it and ensure a good s elf strip.
14
Self-strip door
several inches of label liner.
self-strip door.
strip door to make sure it locks.
PB51 Mobile Label and Receipt Printer User's Guide
Self-strip bar