Intermec PB51 User Manual page 44

Chapter 2 — Con guring the PB51
To con gure the printer to use WEP authentication
1 Send the following commands to login as an admin an d set the
2 Send the following commands to con gure the WEP ke ys. The
To con gure the printer to use WPA-PSK or WPA2-PSK mode
1 Send the following commands to login as an admin an d set the
2 Send one of the following WPA/WPA2 ON commands to t urn on
To con gure the PB51 to use WPA or WPA2 Enterprise mode
1 Send the following commands to login as an admin an d set the
34
SSID:
run"su -p pass admin"
setup write "wlan","uart1:"
setup "wlan","SSID",
where xxxxx can be from 0 to 32 ASCII characters, not includin g
the double quote.
Note: The default password for logging in as an admin is "pass."
If you have changed the password, you will need to use your
password instead of "pass."
following example sets WEP key 1 to 1234 and enables WEP key 1.
setup "wlan","WEP1","0x0001020304"
setup "wlan",".WEP_KEY","1"
setup "wlan","ACTIVE","1"
setup write "wlan","uart1:"
SSID:
run"su-p pass admin"
setup write "wlan","uart1:"
setup "wlan","SSID","
where xxxxx can be from 0 to 32 alphanumeric characters.
WPA or WPA2 authentication. Send the WPA-PSK or WPA 2-PSK
command to set a pre-shared key:
setup "wlan","WPA","ON"
setup "wlan","WPA2","ON"
setup "wlan","WPA_PSK","
setup "wlan","ACTIVE","1"
setup write "wlan","uart1:"
where xxxxxxxxxx is a value between 8 and 64 characters.
SSID:
PB51 Mobile Label and Receipt Printer User's Guide
"
"xxxxx
"
xxxxx
"
xxxxxxxxxx