Intermec PB51 User Manual page 39

The PB51 supports these authentication modes: none, WEP, WPA
Personal and Enterprise mode (802.1x authentication ), WPA2
Personal and Enterprise mode (802.1x authentication).
Note: WPA and WPA2 Enterprise mode currently support PEA P,
TTLS, and LEAP. For LEAP authentication, the PB51 s
EAP, but does not support Network EAP.
To set up the PB51 to work in your wireless network , you will need:
Note: If you are using IPL commands with HyperTerminal, you may
want to be able to see the commands as you type them on your screen.
For help, see
Command Line" on page 25
To set up the PB51 for wireless communications
1 Connect the 8-pin circular DIN connector to the ser ial port on the
2 Connect the other end of the serial cable to a serial port on the
3 Open HyperTerminal on your PC and con gure the fol lowing
PB51 Mobile Label and Receipt Printer User's Guide
Serial cable (P/N 075497-001)
Host PC running Windows or Linux
Serial port software such as HyperTerminal
"Changing Con guration Settings Using the
PB51.
back of your PC or to a serial adapter on your mobi le computer.
parameters for the serial port:
Parameter Default Setting
Baud rate 115200
Data bits 8
Parity None
Stop bits 1
Chapter 2 — Con guring the PB51
.
upports Open
29