Using The Batteries; Installing The Battery - Intermec PB22 User Manual

•
•
•
You can change the amount of time to have elapse before the
backlight turns off using the Setup menu. Options for backlight are
always off, always on, 5 seconds, 10 seconds, 20 seconds, 30 seconds,
or 60 seconds.

Using the Batteries

The PB22/PB32 uses a rechargeable 2250 mAh lithium-ion battery
(Model AB27) for power. You must fully charge the battery before you
can use the PB22/PB32. A fully charged battery can last up to one
week without needing to be recharged when the printer is in Standby
mode.
Use Intermec Model AB27 battery only. Use of another battery
may present a risk of fire or explosion.
The Model AB27 battery may present a fire or chemical burn
hazard if mistreated. Do not disassemble, heat above 100°C
(212°F), or incinerate.
Dispose of used batteries promptly. Keep away from children.

Installing the Battery

Make sure you fully charge the battery before you use your PB22/
PB32. You can charge the battery before or after you install them into
the PB22/PB32.
To install the battery
1 Lay the PB22/PB32 upside down on a flat surface.
PB22/PB32 Portable Label and Receipt Printer User's Guide
Chapter 1 — Using the PB22/PB32 Portable Label and Receipt Printer
you press a button.
you connect the printer to external power.
you are communicating with or sending data to the printer.
7