Intermec PB51 User Manual page 45

2 Send one of the following WPA/WPA2 ON commands to s et up
3 Send these commands to con gure the EAP_TYPE:
4 If you are using TTLS, you may need to send this co mmand to set
5 If you are using certi cates for validation, here are some
PB51 Mobile Label and Receipt Printer User's Guide
run"su-p pass admin"
setup write "wlan","uart1:"
setup "wlan","SSID","
where xxxxx can be from 0 to 32 alphanumeric characters.
WPA-802.1x or WPA2-802.1x authentication. You shoul d also
send the WPA_PSK command that does not contain a value:
setup "wlan","WPA","ON"
setup "wlan","WPA2","ON"
setup "wlan","WPA_PSK",""
setup write "wlan","uart1:"
To view the 802.1x values, send this command:
setup write "8021x","uart1:"
setup "8021x","EAP_TYPE","
where xxxx can be OFF, LEAP, PEAP, or TTLS.
setup "8021x",".EAP_USER","
setup "8021x","EAP_PASS","
where xxxx is the unique username and the unique password for
this protocol.
the TTLS outer name:
setup "8021x","TTLS_USER","
where xxxx is the outer name.
commands you may need to use.
Send the following commands to set a certi cate and enable
validation:
setup "8021x","CA_CERT","
setup "8021x","VALIDATE","ON"
where c:/test.pfx is the location and name of the certi cate and
export is the passphrase.
Send the following commands to set a common name for
server 1 and server 2:
setup "8021x",".SERVER_CN1","
setup "8021x",".SERVER_CN2","
Chapter 2 — Con guring the PB51
"
xxxxx
"
xxxx
"
xxxx
"
xxxx
"
xxxx
c:/test.pfx
xxxxxxxxxx"
xxxxxxxxxx"
@ "
export
35