When Using The Power Key As A Sub Power Off Key - Konica Minolta BIZHUB C3851FS Quick Start Manual

3.2 About Power Supply
Power key
Hold down
Related setting (for the administrator)
-
Press the Power key to select whether to switch to Low Power or Sleep mode.
To configure settings: [Utility] - [Administrator Settings] - [System Settings] - [Power Supply/Power Save
Settings] - [Power Save Settings] (Default: [Low Power])

When using the Power key as a Sub Power Off key

When the Power key is pressed, the status of this machine changes as shown below. Depending on how
long the Power key is pressed, the state of the power save mode to be activated will differ.
Power key
Short press
Hold down
bizhub C3851FS/C3851/C3351
Status of Status of
this ma- LED
chine
Sub Power Light up:
OFF Orange
Status of Status of
this ma- LED
chine
Sub Power Light up:
OFF Orange
ErP Auto Flash:
Power OFF Orange
Description
The power saving effect is the same as that of the sleep
mode.
While the sub power is turned off, this machine can re-
ceive data or faxes, however, it cannot scan or print an
original.
If data or faxes are received while the sub power is
turned off, they are printed when the machine returns to
the normal mode.
To enable the machine to return to the normal mode from
the Sub Power Off status, press the Power key again.
Description
This function reduces power consumption and has a
greater power saving effect.
While the sub power is turned off, this machine can re-
ceive data or faxes, however, it cannot scan or print an
original.
If data or faxes are received while the sub power is
turned off, they are printed when the machine returns to
the normal mode.
To enable the machine to return to the normal mode from
the Sub Power Off status, press the Power key again.
This function provides a greater power saving effect than
the sub power off mode, which is close to the state
where the main power is turned off.
In ErP Auto Power Off mode, this machine cannot re-
ceive data or faxes, and also it cannot scan or print an
original.
To enable the machine to return to the normal mode from
the ErP Auto Power OFF status, press the Power key
again.
3
3-11