Other Features; Returning Settings To The Factory; Default State (Factory Reset); Preventing Unintended Operation (Panel Lock) - Roland V-1SDI Owner's Manual

Other Features

Returning Settings to the Factory-

default State (Factory Reset)

You can return the values of settings on the V-1SDI to
their factory defaults.
If operation that differs from what is described in
the Owner's Manual occurs even when the steps
described are followed correctly, try performing a
factory reset.
NOTE
5 Performing a factory reset causes all settings made and
values saved in memory (p. 13) to be lost.
1.
Display the SETUP menu (p. 12), then select
"FACTORY RESET."
2.
Move the A/B fader to the bus A position.
3.
Make sure the message "PRESS "UP"" is
displayed, and press the [DSK] (
(If you want to cancel the operation, move the
A/B fader to the bus B position or press the
[AUTO] ( ) button.)
A factory reset is executed.
4.
Quit the menu (p. 12).
30
Preventing Unintended
Operation (Panel Lock)
This locks operation of buttons and knobs to prevent
unintended operation of the V-1SDI.
1.
) button.
2.
3.
Display the SETUP menu (p. 12), then select the
targets for panel lock.
You can select the following menu items as
targets for panel lock.
PANEL LOCK (page 10/16)
Menu item Target of panel lock
All controls listed at the PANEL
ALL SW & VOLUME
LOCK menu item
The following buttons on the
RIGHT SW
right side of the panel
DSK [DSK] button
AUTO [AUTO] button
The following buttons on the left
LEFT SW
side of the panel
FREEZE [FREEZE] button
MEMORY [MEMORY] button
AUDIO [AUDIO] button
PANEL LOCK (page 11/16)
The following buttons at the
CENTER SW
center of the panel
[A-1]–[A-4] buttons
A/B BUS
[B-1]–[B-4] buttons
KEY LEVEL [KEY LEVEL] button
WIPE [WIPE] button
MIX [MIX] button
CUT [CUT] button
PinP [PinP] button
SPLIT [SPLIT] button
PANEL LOCK (page 12/16)
The following knobs and the
VOLUME
A/B fader
OUTPUT FADE [OUTPUT FADE] knob
CONTROL 1 [CONTROL 1] knob
CONTROL 2 [CONTROL 2] knob
A/B FADER A/B fader
Use the A/B fader to set panel lock to enabled
(ON) or disabled (OFF).
Quit the menu (p. 12).
The SETUP indicator lights up when an attempt is
made to operate a button, knob, or other control
for which panel lock is enabled.