Connecting Dc Power Cables To The Acx500 Indoor Router; Figure 60: Connecting Ac Power To The Router - Juniper ACX500 Hardware Manual

ACX500 Universal Access Router Hardware Guide
Related
Documentation

Connecting DC Power Cables to the ACX500 Indoor Router

140
Verify that the power cord does not block the air exhaust and access to router
5.
components, or drape where people could trip on it.
Observe the system LED on the router. If an AC power supply is functioning normally,
6.
the system LED lights green steadily.
If the system LED is not lit, the power supply is not functioning normally. Repeat the
cabling procedures.

Figure 60: Connecting AC Power to the Router

ACX500 AC Power Specifications on page 81
ACX500 AC Power Electrical Safety Guidelines and Warnings on page 224
ACX500 General Electrical Safety Guidelines on page 219
To connect DC power to the router, you need the following tools:
Phillips (+) screwdriver, number 2
Electrostatic discharge (ESD) grounding wrist strap
M3 screws and flat washers
DC power source cables, minimum 14 AWG or as required by local code (not provided)
Ring lugs, Molex 190700067 or equivalent (not provided)
NOTE: Power cables for the ACX500 indoor routers are not shipped with the
routers. You need to purchase the power cord separately.
The DC power supply has four terminals on the front panel, covered by a clear plastic
cover.
WARNING: You must ground the router before connecting the DC power
cables.
Copyright © 2016, Juniper Networks, Inc.