Acx500 Outdoor Router With Poe Chassis Dimensions And Clearance Requirements; Figure 27: Acx500 Outdoor Router Chassis Dimensions And Clearance Requirements-Top View - Juniper ACX500 Hardware Manual

ACX500 Universal Access Router Hardware Guide

ACX500 Outdoor Router with PoE Chassis Dimensions and Clearance Requirements

64
Figure 27: ACX500 Outdoor Router Chassis Dimensions and Clearance
Requirements—Top View
Prepare your site for installation by observing the following guidelines:
When installing the ACX500 outdoor routers on a pole or on a wall, the chassis must
be installed in a vertical orientation with the cables pointing downward and the eye
bolt for hoisting the router pointing upward.
Figure 28 on page 65 and
outdoor router after installation.
When choosing a location, allow at least 6 in. (15.2 cm) of clearance between the sides
of the chassis (with the router in installed position) and adjacent equipment or walls.
See Figure 28 on page 65.
Ensure that the wall or the pole onto which the router is installed is stable and securely
supported.
Ensure that the wall or pole is able to carry the load of the fully configured router.
If you are mounting the router in wallboard with a gypsum plaster core or in wallboard
not backed by wall studs, use hollow wall anchors capable of supporting the combined
weight of two fully loaded chassis. Insert the screws into wall studs wherever possible
to provide added support for the chassis.
The width of the pole must be within the range of 2 in. through 16 in. for the
pole-mounting brackets to fit properly.
Figure 29 on page 66 show the orientation of the ACX500
Copyright © 2016, Juniper Networks, Inc.