Chapter 4
First-Time Setup
Place the small spirit level on top of the camera. If the camera is not level, adjust the camera using the
Step 2
camera rotation screws until the camera is level.
Figure 4-8
Attaching the Large Camera Target to the Easel
To unpack and build the easel and large camera target, complete the following steps.
Remove the easel, large camera target, and small camera target from their packaging.
Step 1
Unlock and slide the telescoping legs of the easel until the legs are at their full height.
Step 2
Separate the three legs.
Step 3
Raise the front legs until they are 29 inches (74 cm) high.
Step 4
Raise the rear leg until it is 31 inches (79 cm) high.
Step 5
Lock the legs into place using the leg locks.
Step 6
Step 7
Attach the large camera target to the clip on top of the easel.
Step 8
Raise the target supports on the front legs until they touch the lower part of the large camera target.
Step 9
Raise and lower the front legs until the bottom of the camera target is 32 inches (81 cm) above the
ground.
OL-19695-01
Leveling the Camera Assembly
Camera
Level
rotation
screw
Cisco TelePresence System 1100 Assembly, First-Time Setup, and Field Replaceable Unit Guide
Camera
rotation
screw
Setting Up the Camera
4-15